Home Login

 Solid Model Memories
Solid Model Memories Member Gallery
Member's Forum Album list Last uploads Last comments Most viewed Top rated My Favorites Search
Home > User galleries > Oceaneer99 > Bristol Spaceplanes Ascender (1/72 scale)
Return to the thumbnail page FILE 80/130 Return to start See previous file See next file Skip to end
07. Top view piece Normally, I tack glue the scrap from the top to glue the top-view on, but since I only had the front and tail to cut, I split the top-view and attached it to the shaped top. As you might guess, this is not perfectly accurate, but for these cuts was just fine. I slipped the wing cut-out back into place before cutting, to have a flat surface to run into the saw. Keywords: bristol spaceplane ascender model

07. Top view piece

Normally, I tack glue the scrap from the top to glue the top-view on, but since I only had the front and tail to cut, I split the top-view and attached it to the shaped top. As you might guess, this is not perfectly accurate, but for these cuts was just fine. I slipped the wing cut-out back into place before cutting, to have a flat surface to run into the saw.

I-16_Parts.JPG VKA-23_Rough_Shaped.jpg P1040569.JPG 1462102566_0bd690d07f_b.jpg I-16FinisedTop.JPG
File information
Filename:P1040569.JPG
Album name:Oceaneer99 / Bristol Spaceplanes Ascender (1/72 scale)
Keywords:bristol / spaceplane / ascender / model
Filesize:348 KiB
Date added:Jan 14, 2008
Dimensions:1000 x 668 pixels
Displayed:177 times
URL:http://smm.solidmodelmemories.net/Gallery/displayimage.php?pid=229
Favorites:Add to Favorites
 

Powered by Coppermine Photo Gallery