Author Topic: Flyer Toon.  (Read 43 times)

0 Members and 1 Guest are viewing this topic.

buccfan

  • Moderator
  • Hero Member
  • *****
  • Posts: 643
Flyer Toon.
« on: January 20, 2018, 03:21:12 PM »
Just a couple of images showing progress so far. Fuse and wing glued together but fin is just pinned in place. Intakes and nozzles work in progress. Apologies for image quality will try to get some better ones as it progresses. Regards Paul.
   

lastvautour

  • Administrator
  • Hero Member
  • *****
  • Posts: 6252
Re: Flyer Toon.
« Reply #1 on: January 20, 2018, 03:33:08 PM »
Sweet looking Toon. Are your wings laminated as the grain appears to change directions?

lou

Boomerang

  • Hero Member
  • *****
  • Posts: 868
Re: Flyer Toon.
« Reply #2 on: January 20, 2018, 05:43:37 PM »

 Looking Good Paul.

 Gordon

buccfan

  • Moderator
  • Hero Member
  • *****
  • Posts: 643
Re: Flyer Toon.
« Reply #3 on: January 21, 2018, 03:04:12 AM »
Thank you Lou and Gordon, the wing was cut from a block of laminated pine board on which the strips are glued together with opposite grains to make them stronger, supposedly to stop them cupping on wide boards, as I was only cutting the thin wing without much chiseling it worked out OK. Regards Paul J.