• Welcome to Solid Model Memories.net.
 

1/32 Delanne 20T-02 started July 2011 Completed 14 April 2015

Started by Boomerang, January 12, 2015, 10:17:10 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Boomerang

  As with the Flycatcher revisiting the Delanne.
  I guess I've had an extended modeller's block with this one.
   I'm not sure of the colour scheme.
  I've done it red with gold trim. But it could be blue.
 
All depends on the type of film used etc..,

  http://histoiredelacourte.unblog.fr/tag/delanne-dl-20-t2/

  If you look at the link above this gives probably the best set of pics around ( that I can find).
 
  Cheers
  Gordon

lastvautour

#1
Looks good in red.
Lou

Boomerang


  Rather than procrastinate I've decided to go with Red . The fuselage stripes etc.. will be gold with a fine edge of black.
  This is based on black and white picture I came across of another aircraft that is painted as such.
  It will be the subject of another project a little further down the track.

  Cheers
  Gordon

lastvautour

Should work out well. I await your progress.

Lou

Boomerang


  From further research the "future" project will burgundy with gold trim and registration.

  On with the Delanne.

  Gordon

Boomerang

 
  Nose surgery has been performed . Had to trim the nose down by 1/16 th then reshape the lower nose.
  The main inlet was shaped and a piece of appropriatly shaped plastic food container was inserted then a small amount of
  filler to provide the lip. The right hand side is a scoop. Again plastic food container used.
  Spinner adjusted to suit.  Slats have been cut from doped and primed paper.
  I've had the struts made for some time. I'll add some copper wire to the ends to serve as locating pins.
  These will the last to go on as I've got tp do the fuselage striping.
  Pics to follow

Gordon     

lastvautour

Nice to hear from you on your three projects. Looking forward to some pictures.

Lou

Boomerang


  Not the best pic . Still some cleaning up to do.

 

lastvautour


Boomerang


Slats added. Pins (copper wire) added to wing struts to make fitting a bit easier.

Boomerang


  Struts have been pinned to aid assembly.
  More coats of red applied. Have to cut back some minor "bubbling" on the left side of fuselage.
  Propeller painted. Rear of blades will be black.
   Leaving struts  and spats off till I've managed to do the fuselage stripe

lastvautour

From this angle you finish looks perfect.

Lou

Boomerang


  Fuselage and spats have now had the gold trim applied. Have given the canopy a couple of coats of white.
  Looks a bit to bright against the red so I'll think about knocking it back a bit with a light wash of grey or green.
Pic to follow

lastvautour

#13
A wash should tone it down for you. I await the photos.

Lou

Boomerang


  Should be able to put a pic shortly