Recent Posts

Pages: [1] 2 3 4 5 ... 10
1
Lou's Projects / Re: 1/32 AL-60 Conestoga
« Last post by lastvautour on January 21, 2018, 01:44:34 PM »
Yes. If I can't match the red on the PC, I will print the decal grey on clear and paint over that.

Lou
2
BuccFan's Project Board / Re: Flyer Toon.
« Last post by buccfan on January 21, 2018, 03:04:12 AM »
Thank you Lou and Gordon, the wing was cut from a block of laminated pine board on which the strips are glued together with opposite grains to make them stronger, supposedly to stop them cupping on wide boards, as I was only cutting the thin wing without much chiseling it worked out OK. Regards Paul J.
3
Lou's Projects / Re: 1/32 AL-60 Conestoga
« Last post by Boomerang on January 20, 2018, 05:45:10 PM »

  Looks great Lou.

 Homemade decals?

 Gordon
4
BuccFan's Project Board / Re: Flyer Toon.
« Last post by Boomerang on January 20, 2018, 05:43:37 PM »

 Looking Good Paul.

 Gordon
5
Lou's Projects / Re: 1/32 AL-60 Conestoga
« Last post by lastvautour on January 20, 2018, 03:34:03 PM »
Thank you Paul.

Lou
6
BuccFan's Project Board / Re: Flyer Toon.
« Last post by lastvautour on January 20, 2018, 03:33:08 PM »
Sweet looking Toon. Are your wings laminated as the grain appears to change directions?

lou
7
Lou's Projects / Re: 1/32 AL-60 Conestoga
« Last post by buccfan on January 20, 2018, 03:23:16 PM »
Looking good Lou. Regards Paul.
8
BuccFan's Project Board / Flyer Toon.
« Last post by buccfan on January 20, 2018, 03:21:12 PM »
Just a couple of images showing progress so far. Fuse and wing glued together but fin is just pinned in place. Intakes and nozzles work in progress. Apologies for image quality will try to get some better ones as it progresses. Regards Paul.
   
9
Lou's Projects / Re: 1/32 AL-60 Conestoga
« Last post by lastvautour on January 20, 2018, 10:55:09 AM »
Italian red paint arrived a few days ago and was put to use immediately. Now for the decals. Note the wing braces are not installed.

Lou


Photo credit Jeroen Stroes, Netherlands
10
The hull blocks are rough cut out of recycled mahogany baseboards like the remainder of my 1/350 ships.

Lou
Pages: [1] 2 3 4 5 ... 10