Hi Jim

I did a little research and I would suspect there is either an issue with the "drying chemicals" not being evenly distributed when you applied the base coat. Or there was a humidity / temperature issue. If it's a moisture issue, I would suggest trying the hair dryer on low and keeping it a good distance away from the affected areas. Rather than a prolonged exposure to the hair dryer, it may be better to apply heat in frequent short duration applications (1 or 2 minutes). You should be able to test the temperature by testing on a scrap of wood and then touching the surface to see how hot it becomes. I would try for a "warm to the touch" duration. by adjusting the distance from the model and also the angle of air flow impingement, you should be able to obtain an acceptable temperature. In my opinion a heat gun would create too much risk.

Good luck and let us know the outcome of your efforts. - ken

If the issue is a chemical issue rather than an evaporation issue you may wish to go over the affected areas with a reapplied light coat to re-introduce the curing chemicals ensuring the temperature and humidity conditions are correct. This would be a little risky in the event the second light coat hardens and seals in the softer first coat.

Seeking advice: Anyone have advice on what to do when paint or clearcoat won't dry completely?
I've recently completed building a new model, but can't finish the job because the paint doesn't seem to want to dry completely. Not all of it, mind you. Just a few spots on the wings and fuselage. To explain:

My usual practice is to paint the model with acrylics, then after drying, give it a coat of clear enamel (Floquil Railroad Colors Crystal Clear-Cote) to provide a smooth, shiny surface that the decals can best adhere to. Sometimes, if it's particularly humid or cold in the workshop, this may take a day or more to dry completely. Then, after attaching the decals and letting them set, I like to give everything a final coat of Crystal-Cote to seal the decals and make everything look sharp visually.

But this time, for some strange reason, the primary layer of clear-coat won't seem to dry completely. It remains tacky in spots a good two weeks after application. I set it aside in a climate-stable space, but the tackiness persists. I'm concerned that applying decals and another coat of crystal will result in disaster. I've thought about hitting it with a heat gun or hair dryer, but the idea of what might happen gives me the fantods!

Anybody have any ideas or suggestions what to do?

Thank you Gordon.

 Looks fantastic Lou !

 Well done.

 Gordon

NV Deborah
The Newfoundland Vessel Deborah is a brig used in coastal water to protect shipping lanes from pirates.

Lou

Thank you Lou.

Decals to be sorted yet.

 Gordon

 Thank you Lou.

 It is 1/48.

 Didn't reduce the scrap box by much.

 Cheers

 Gordon

You can get them as wide as 2.5cm. I have three different sizes. They are stiff so anything that requires strength is a good place for them.

Lou

Seen them called "craft sticks"

Gordon's builds

Bell XP-77
1/48 Scale
14 May 2024