Solid Model Memories

Solid Model Memories Member Gallery
Home > User galleries > SMM/RFBennett > 4 inch Drawknife Build
4 inch Drawknife Build Image 9
The handles are drilled out with a 7/32" bit from the ferrule end. This is for an approximately 1/4" tang. No glue is needed once you drive them on they aren't coming off unless you break them. Sharpen with progressively finer stones and as needed rub in a good bit of boiled linseed oil into the handles and onto the blade to prevent rust. If used on fresh or wet wood clean it up and reapply the oil. If you use other nondrying oils such as mineral oil or WD40 this oil could rub off on your project and effect the finish. Use only Boiled linseed oil.
Keywords: Drawknife

4 inch Drawknife Build Image 9

The handles are drilled out with a 7/32" bit from the ferrule end. This is for an approximately 1/4" tang. No glue is needed once you drive them on they aren't coming off unless you break them. Sharpen with progressively finer stones and as needed rub in a good bit of boiled linseed oil into the handles and onto the blade to prevent rust. If used on fresh or wet wood clean it up and reapply the oil. If you use other nondrying oils such as mineral oil or WD40 this oil could rub off on your project and effect the finish. Use only Boiled linseed oil.

4_in_Drawknife_image_01_Small.jpg Lutz_File_Handle_No_1C_Small.jpg 4_in_Drawknife_image_09_Small.jpg 4_in_Drawknife_image_08_Small.jpg 4_in_Drawknife_image_06_Small.jpg
File information
Filename:4_in_Drawknife_image_09_Small.jpg
Album name:SMM/RFBennett / 4 inch Drawknife Build
Keywords:Drawknife
Source::R.F.Bennett
Copyright::R.F.Bennett 2008
Filesize:186 KiB
Date added:May 04, 2008
Dimensions:800 x 218 pixels
Displayed:294 times
URL:http://smm.solidmodelmemories.net/Gallery/displayimage.php?pid=1410
Favorites:Add to Favorites